![]() x 8.5in.) size drawing of the assembly with balloons and a parts list. What is the first value of the center of mass? 52.7086 mm Create an ASME A (11in. Reset the animation so the Drive joint is in the new position. ![]() Make sure it always returns to the -10 degree position. What is the first value of the center of mass? 52.6703 mm Update the assembly using the following steps: Note: Once connected the mechanism will be held in place. What is the mass of the new component? 6.186 grams Finish connecting the assembly using the following information:įix component 103 in place and release component 105 Create a component from body 113.Īdd body Pin and 114 to the new component. ![]() What is the new lxx value for the Moment of Inertia at Center of Mass? 289.313. What is the new mass of this component in grams? 44.593 grams Relocate the set screw hole to be 15 degrees off the XZ plane. What is the new mass of this component in grams? 12.335 grams Create a relief for mounting a component using the Pad Sketch 7 mm above the Pad Sketch plane and 10 mm high without using construction planes. What is the new mass of this component in grams? 24.16 grams Remove volume from the part so that the wall is 1 mm thick and there is a 12.8 mm diameter opening centered on the flat end. Update the pattern to create 12 fins with fillets equally spaced and flush with the end of the cylinder. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |